Stirrer Accessories
Chemglass Life Sciences Stirrer Shaft, Polished, 10mm, 70mm OD x 15mm Wide, 90° Four-Blade Glass Agitator, 455mm OAL
A 10mm precision ground stirrer shaft to fit CG-2070 through CG-2072 10mm bearings. Side button for attachment of CG-2080 or CG-2081 PTFE stirrer blades. PLEASE NOTE: THESE SHAFTS ARE NOT TO BE USED WITH ANY TYPE OF PTFE BEARING. FOR POLISHED SHAFTS USED WITH PTFE BEARINGS SEE CG-2079.
Chemglass Life Sciences Agitator, 90°, 5.5" OD, PTFE, 19mm shaft, Supplied with one Glass Filled PTFE Pin
Agitator, 90, 5.5" OD, PTFE, 19mm shaft, Supplied with one Glass Filled PTFE Pin
Med Vet International 3.5mm x 20mm Titanium Cortical Self-Tapping Screws, J1074CT, 6-Pack
Many fractures in feline and small canine patients are too small for the 2.0mm DCP and the 2.7mm CDP is too large.The difference between these plates is enormous compared to the difference between 2.7 and 3.5 CDPs. The AMI (resistance to bending) of the 2.7 CDP is 20 times stiffer than the 2.0 DCP. The AMI of the 2.4 DCP is 10 times that of the 2.0 DCP.The solution is a 2.4 series of plates and screws. The plates in both size and strength are midway between 2.0 and 2.7 DCPs. The range and specifications are shown below. The standard 1.5mm hex screwdriver (used for 1.5 and 2.0 screws) is required. The pilot drill is 1.8mm and dedicated instrumentation such as load/neutral guides are also available.
CARLISLE SANITARY MAINTENANCE PRODUCTS REPL BLADE 4-1/2INX7-1/2IN 6CS
NC1456180 REPL BLADE 4-1/2INX7-1/2IN 6CS
Med Vet International 2.4mm x 28mm Titanium Cortical Self-Tapping Screws, J1073JT, 6-Pack
Many fractures in feline and small canine patients are too small for the 2.0mm DCP and the 2.7mm CDP is too large.The difference between these plates is enormous compared to the difference between 2.7 and 3.5 CDPs. The AMI (resistance to bending) of the 2.7 CDP is 20 times stiffer than the 2.0 DCP. The AMI of the 2.4 DCP is 10 times that of the 2.0 DCP.The solution is a 2.4 series of plates and screws. The plates in both size and strength are midway between 2.0 and 2.7 DCPs. The range and specifications are shown below. The standard 1.5mm hex screwdriver (used for 1.5 and 2.0 screws) is required. The pilot drill is 1.8mm and dedicated instrumentation such as load/neutral guides are also available.